Why should the drive in rack in cold storage warehouse be controlled within 10 meters

- Oct 19, 2020-

The drive in rack is composed of frames, bracket beam, top beam, middle beam, top tie, back tie and so on. This kind of rack is suitable for the storage mode with relatively few varieties and integral whole. Because the forklift truck can drive into the storage area only by arranging the aisle, the warehouse utilization rate is high, and it is mostly used in cold chain logistics, beverages, food, dairy products and other fields.

 

Drive in rack system has the typical characteristics of FILO. Forklift trucks are usually operated in the mode of continuous "lifting and hitting" with a high center of gravity after lifting. Forklift trucks are prone to sway into the racks with the unevenness of the ground in the corridor, which will affect the stability and safety of the rack structure. The technical requirements are relatively high, and the turnover speed and efficiency of goods are also affected to a certain extent.

 

The structure design of the drivein racks is the key factor to determine the quality of the racks. In addition, the material, production technology, production equipment, fixtures and powder coating, etc. will directly affect the quality and grade of the racks. The main structure of the rack is a space steel structure. It is very complicated to calculate its strength, stiffness and stability by the traditional classical mechanics method or dynamic method. Simplified calculation model can be used to analyze and optimize the structure in combination with domestic and foreign standards and test data. At present, most of the finite element structural strength analysis and stability analysis are used for auxiliary design and full-scale load test verification.

 

In order to ensure its stability, the slenderness ratio of uprights should not be too high. Generally, it should be controlled within 10 meters and more than 4 layers and 3 to 5 rows. Compared with the same kind of pallet racks, in addition to the steel section specifications to be larger, but also need to install tensile fasteners. The main fittings of the drivein rack include frame, top beam, top bracing, back bracing, guide rail, upright protector or frame protector and so on.

 

In the design process of the drivein rack, first of all, the standardization of the pallet unit should be carried out to determine the size, stack height and rated load of the pallet.Then the overall structure of the drivein rack and the key dimensions of the storage unit, such as span, depth, spacing and height, can be planned to carry out the structure and components of the rack. In design, the key parameters should be verified by design or test, the simplified mechanical model should be established according to the case structure, and the strength, stiffness and stability should be set up according to the actual force (including seismic load) and load distribution of the rack, and the geometric parameters and mass characteristics of the corresponding components. If necessary, can be verified through experiments to ensure that the design results are in line with the actual situation.

 

Welfor is specialized in producing various pallet rack, cantilever rack, medium duty rack, mezzanine and platform, slotted angle shelving, push back rack, longspan rack, rivet rack, drive in rack, carton flow rack, stacking rack and other related storage equipment.

 

Welfor strictly implements ISO9001, FEM10.2.02, SEMA, AS4084 and RMI standard in all operations. Welfor offers a wide range of products to meet all of your order fulfillment & material handling needs: pallet rack and cantilever rack. Whether you are looking to populate an entire warehouse or you are in need of a single piece of equipment, Welfor has a solution for you.